Skip to content
GoGGa's Workshop. Make it happen!
YouTube videos Tools I use
GoGGa's Workshop › Shop jigs & setup

Mounting Festool tracks on the wall

Shop jigs & setup · 2:04 · Jan 27, 2026

I 3D printed a jig to mount my tracks on the wall. Better-looking, more accessible, more organized, etc. This is the way to go, for sure.

Watch on YouTube (opens in a new tab) Subscribe (opens in a new tab) Buy me a coffee (opens in a new tab)

More shop jigs & setup

  • Shop rags organizer from junk I don't use anymore + new casters1:12Shop rags organizer from junk I don't use anymore + new casters
  • Why This Table Saw Jig Belongs in the Trash2:57Why This Table Saw Jig Belongs in the Trash
  • The Dangerous Thin Rip Jig I Just Had to Test2:20The Dangerous Thin Rip Jig I Just Had to Test
  • Connect SmallRig Magic Arm to Festool MFT table2:50Connect SmallRig Magic Arm to Festool MFT table
  • A better Magic Arm connector for the Festool MFT table4:33A better Magic Arm connector for the Festool MFT table
  • Magic Arm connector for the Festool MFT table4:18Magic Arm connector for the Festool MFT table

← All videos

© 2026 GoGGa's Workshop by Greg Fridman youtube.com/@goggasworkshop