Dixie Belle Patina Paint — First Test, On a 3D-Printed Fountain

Finishing & restoration · 3:32 · Jun 26, 2026

Real talk: I didn't set out to make a fountain. I wanted to test this Dixie Belle Patina Paint (Bronze) and the green patina spray that goes with it. The fountain was the excuse.

Modeled it in 3D, printed it overnight, chamfered edges, glued the whole thing together with 5-minute epoxy (that you and I both know takes 24 hours to actually set). Printed a connector for the tubing. Sawed off one side to route the power cable — thin curved cut — then carved a little trench for the wire and glued it all back together.

Sanded, wiped down with isopropanol, primed off camera, then the fun part: bronze patina paint with actual metal particles in it. Hit it with the green patina spray. A few minutes later — still bronze. Next morning — whoa. Properly rustic.

Sealed it with 3 coats of Dixie Belle Gator Hide for matte protection, let it cure, assembled everything, and done.

I'm going to have a lot of fun with this paint.